Removing the bearing bracket for pedal mechanism

Preliminary work 

• Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
• Refer to REMOVING THE BRAKE LIGHT SWITCH .

• Retract release tool 2 409 646  between brake pedal and brake booster.
• Apply support (1)  of the release tool 2 409 646  on the bearing bracket. If necessary, position the support by rotating the screw on the release tool.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press release tool 2 409 646  in the arrow direction and lever out the brake pedal from the brake booster.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Disconnect plug connection (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Unlock plug connection (1)  and disconnect.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen nuts (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release screw (1)  and remove bearing bracket (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.