Install The Outer Section Of The A-Pillar
NOTE:
TECHNICAL INFORMATION
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
- Pre-clean the bonded rivet connection (1)
with cleaning agent R2.
CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean the bonded rivet connection (1)
with cleaning agent R1.
CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K1 to bonded rivet connection (1)
.
ADHESIVE SPECIFICATION
Body adhesive K1 195 ml 83190413015 NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Installation of cavity sealing (expanded) - Apply sealant D1 to the cavity sealing elements (2)
.
CONSUMABLE SPECIFICATION
Sealant D1 (seam sealing) 310 ml 83425A547B4 - Install the new part and the reinforcement plates.
- Set in the area (1)
blind rivet N7.
CONSUMABLE SPECIFICATION
Blind rivet N7
Ø 6.5 mm; clamping area 1.5 - 3.5 mm83192240352 - Weld the new part and reinforcement plate in areas (2)
to (4)
as per new part preparation process.
In the areas (2) and (3) , hereby observe the procedure for replacing spot-welded adhesive joints from standard production.
- Weld the new part and reinforcement plate in areas (1)
and (2)
as per new part preparation process.
In the area (2) , hereby observe the procedure for the replacement of spot-welded adhesive joints for the standard production.