Removing The Outer Section Of The A-Pillar

Release welded connections in areas (1) .
Release the brazed connection in area (2) .
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Releasing bonded connections
Open spot-welded adhesive joints in areas (3) .
NOTE:
RISK OF DAMAGE
Damage to bonded connection .
Influence of heat that is too large leads to damage on bonded connections lying on the beading or below .
- Warm bonded connection only for a short time, maximum up to 120°C.
Courtesy of BMW OF NORTH AMERICA, INC.
Do not damage the bonded connections in the areas (4) between the panels located underneath!
Release bonded connection in area (5) .
Release the outer section of the A-pillar from the cavity sealing (6) and remove.