Install The Outer Section Of The A-Pillar
NOTE:
TECHNICAL INFORMATION
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
- Pre-clean adhesive area (1)
on the body and on the new part with cleaning agent R2.
CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean adhesive area (1)
on the body and on the new part with cleaning agent R1.
CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K1 to bonded rivet connection (1)
.
ADHESIVE SPECIFICATION
Body adhesive K1 195 ml 83190413015 NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Installation of cavity sealing (expanded) - Apply sealant D1 to the cavity sealing elements (2)
.
CONSUMABLE SPECIFICATION
Sealant D1 (seam sealing) 310 ml 83425A547B4 - Install the new part and the reinforcement plates.
- In area (1)
set blind rivet N6.
CONSUMABLE SPECIFICATION
Blind rivet N6
Ø 4 mm; clamping area 3-5 mm83192158655 - In areas (2) and (3) , weld the new part and reinforcement plates according to the new part preparation process.