Preparing New Part
- Mark the separating cut on the new part according to the separating cut on the vehicle + 20 mm added material and cut.
- Adjust the new part in combination with the side panel to fit and secure.
- Prepare joins by welding in area of overlap (1) .
Replacing the coarse thread bolt and threaded weld bolt (steel surface)
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Renew the coarse thread bolt (1)
and the threaded weld bolt (2)
.
Parts: Coarse thread bolt, threaded weld bolt
Take the number and position from the component to be replaced or the add-ons.
- Weld coarse thread bolt (1) and threaded weld bolt (2) onto the new part.