Installing The Rear Luggage Compartment Floor
Precondition
Bonding surfaces are cleaned.
NOTE:
TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
- Apply adhesive K5 to the bonding surfaces.
ADHESIVE SPECIFICATION
Body adhesive K5 50 ml 83192158654 - Install new part.
- Set blind rivets N3 in area (1) .
CONSUMABLE SPECIFICATION
| Blind rivet N3 Ø 4 mm; clamping area 1-3 mm |
83190301421 |
Installing the EMC screw
- Drill the hole with a diameter of 4.2 mm after the adhesive completely hardens.
- Screw in the EMC screw.
CONSUMABLE SPECIFICATION
Screw
EMC screw, SF Plus, M5x1583190301639 - Seal the EMC screw with the sealant.
CONSUMABLE SPECIFICATION
| Sealant D2 | 290 ml | 83425A547B9 |
NOTE:
Perform the steps on the left and right side.
- Set blind rivets in area (1) .
- Once the adhesive has hardened, install 1 x EMC screw in the area marked (2) .
CONSUMABLE SPECIFICATION
| Screw EMC screw, SF Plus, M5x15 |
83190301639 |
Replacing the coarse thread bolt and threaded weld bolt (steel surface)
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Renew the coarse thread bolt (1)
and the threaded weld bolt (2)
.
Parts: Coarse thread bolt, threaded weld bolt
Take the number and position from the component to be replaced or the add-ons.
- Weld coarse thread bolt (1) and threaded weld bolt (2) onto the new part.