Installing The Left Luggage Compartment Floor
NOTE:
TECHNICAL INFORMATION
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
For the repair, only use approved spot welders.
For additional information see: 41 00... Workshop equipment
- Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.
CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surfaces on vehicle and on new part with cleaning agent R1.
CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K5 to the bonding surfaces.
ADHESIVE SPECIFICATION
Body adhesive K5 50 ml 83192158654 - Install the new part and rivet in areas (1)
to (3)
with blind rivets.
Area Blind rivet 1 N1 2 N2 3 N1 CONSUMABLE SPECIFICATION
Blind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm83190301414 CONSUMABLE SPECIFICATION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (4)
.
Avoid applying too much heat to the adjacent adhesive area (3) .
NOTE: To provide a better overview: Shown without side panel and without tail panel. - Rivet the new part in the area (2)
with blind rivets N2.
CONSUMABLE SPECIFICATION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (1)
.
Avoid applying too much heat to the adjacent adhesive area (2) .
- Weld the new part in the area (1)
.
- Weld the new part in the area (1) .