Preparing the rear spoiler
- Carefully remove the adhesive residue from the rear spoiler.
CONSUMABLE SPECIFICATION
| Adhesive remover | 1 l, Can | 83110009712 |
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | ||
|---|---|---|
| Cleaning agent R2 | 2 min | |
- Check the rear spoiler.
Do not install rear spoilers with poor fitting accuracy.
Any rear spoiler positioned loosely on the tailgate must be in contact with the tailgate over the entire area and at the corners in particular.
- Clean the bonding surface on the rear spoiler.
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
- Place adhesive strip (1)
on the rear spoiler and align it.
In the center of the spoiler (arrow), leave a gap of approx. 2 mm on the adhesive strip (1) .
- Pull off the protective film for the bonding surface from adhesive strip (1) and stick it on the rear spoiler.
- Press on the adhesive strip (1) with your thumbs or the back of your hand over the entire area since the adhesion of the adhesive tape builds up significantly through contact pressure.