Installing transmission cross member

• Install transmission cross-member.
• Replace the screw (1).

  Parts:  Screw

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission cross member to rubber mounts
  M12	Tightening torque	100 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (2)  .

  Parts:  Screws

• Tighten down screws (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission cross member to body
  M8	Tightening torque	19 Nm

• Remove the transmission jack.

Follow-up work 

• Refer to INSTALLING TRANSMISSION CROSS MEMBER .
• Refer to INSTALLING REAR UNDERBODY PROTECTION .