Installing the steering shaft seal
- Fully push in the steering shaft.
- Position the steering shaft seal (1) .
- Tighten the nuts (see arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Bearing plate to firewall | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Position the cover of the steering shaft seal (3) .
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Cover to firewall | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
- Check the holder (2) and replace if necessary.
- Clip in the holder (2) at the refrigerant lines (3) .
- Secure the coolant hoses (1) at the holder (2) .
Follow-up work
- Refer to INSTALLING THE HEAT INSULATION .
- Refer to INSTALLING THE UNIVERSAL JOINT AT THE BOTTOM OF THE STEERING SHAFT .
- Refer to INSTALLING CHARGE AIR PIPE ON LEFT .
- Refer to INSTALLING TOPPING CLEAN AIR PIPE ON LEFT .
- Refer to INSTALLING THE LEFT THROTTLE BODY .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CHECKING THE STRAIGHT-AHEAD DRIVING POSITION OF THE STEERING WHEEL .
- Refer to CHECKING THE AIRBAG FOR FUNCTION .