Removing the Lambda oxygen sensor
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE COWL UPPER PART IN THE CENTER .
- Refer to REMOVING THE RIGHT THROTTLE BODY .
- Refer to REMOVING TOP RIGHT CLEAN AIR PIPE .
- Refer to REMOVING RIGHT CHARGE AIR PIPE .
- Unlock and disconnect connector (1) .
- Release connector (1)
from carrier plate.
- Cut open the cable tie (1)
.
- Detach the cable (1)
from the clamp (2)
.
- Prepare tools:
Join the swiveling extension (1), the special tool 0 493 751 (11 9 150) and 0 491 075 (11 7 030).
- Release the Lambda oxygen sensor (1) with the special tools 0 493 751 (11 9 150) and 0 491 075 (11 7 030).
- Remove the Lambda oxygen sensor (1) .