Removing the radial shaft seal in the timing case cover on the bottom
Preliminary work
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING BOTH HEADLIGHTS .
- Refer to REMOVING THE CENTER TOP CROSS CONNECTION .
- Refer to REMOVING THE FANFARE HORN ON THE LEFT .
- Refer to REMOVING THE FANFARE HORN TOWARDS THE RIGHT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE LEFT-HAND AIR DUCT .
- Refer to REMOVING RIGHT AIR DUCT .
- Refer to REMOVING LEFT INTAKE PORT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING FAN COWL .
- Refer to INSTALLING THE PROTECTIVE SHIELD ON THE RADIATOR .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR 2 AND THE AIR CONDITIONING COMPRESSOR .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR .
- Refer to REMOVING THE BELT PULLEY .
- Refer to REMOVING THE VIBRATION DAMPER .
- Position all levers (2) of the special tool 0 493 923 (11 9 410) horizontally to pull off the radial shaft seal (1) .
- Turn the spindle of the special tool 0 493 923 (11 9 410) back until all levers (2) can be positioned at the
sealing lip.
- Turn all levers (2) so that the levers (2) behind the radial shaft seal (1) engage.
- Turn the spindle (3) on the special tool 0 493 923 (11 9 410) and detach the radial shaft seal (1).