Replacing the cylinder head (remounting components)

• Release the venting connector (1)  at the cylinder head (3)  .
• Release the coolant temperature sensor (2)  at the cylinder head (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the cylinder head (3)  .

  Parts:  Cylinder head

• Tighten venting connector (1)  on cylinder head (3)  .

TIGHTENING TORQUE SPECIFICATIONS

Venting connector/special tool to cylinder head
M10	Tightening torque	18 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the coolant temperature sensor (2)  on the cylinder head (3)  .

TIGHTENING TORQUE SPECIFICATIONS

Coolant temperature sensor at cylinder head
Sensor	tightening torque	18 Nm