Installing the electric changeover valve for the engine mount

• Note that the green O-ring (1)  marks the connection of the controlled vacuum.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the vacuum hose (1)  for the engine mount to the marked connection of the electric changeover valve (4)  .
• Connect the vacuum hose (1)  from vacuum reservoir to the electric changeover valve (4)  .
• Connect and lock the connector (3)  .

  The connector (3)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the electric changeover valve (2)  in the direction of the arrow. 
• Ensure that the locking mechanism (1)  engages audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install coolant line (1)  .

  The coolant line (1)  must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTAKE PLENUM .
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to INSTALLING CONTROL UNIT BRACKET .
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE RESONATOR WITH THE TOP CLEAN AIR PIPE .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .