Removing the electric vacuum pump
WARNING:
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see:
- For additional information see:
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to REMOVING THE WHEEL .
- Refer to REMOVING REAR SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to REMOVING THE UNDERSHIELD ON THE RIGHT FRONT SIDE .
- Unlock plug connection (1) and disconnect.
- Unlock and detach snap fastener (2) .
- Detach the vacuum line from the holders (3)
.
- Loosen the screws (1)
and lower the electrical vacuum pump (2)
.
- Detach the vent hose (1) in the direction of the arrow.
- Removing the electrical vacuum pump.