Preparing New Part
NOTE:
TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
- Mark and make the separating cuts on the new part in accordance with the separating cuts on the vehicle.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Reinforcement plate with stud bolt (glued or welded) - Prepare reinforcement plates at separating cuts (bonded and welded).
- Adjust new part to fit and secure.
- Areas (1) and (2): Drill ø 4.2 mm holes for blind rivets.
Area Number 1 5 2 2 - Areas (1) to (3): Drill ø 4.2 mm holes for blind rivets.
Area Number 1 4 2 3 3 1 - Remove new part and deburr bores.
- Prepare remaining areas for bonded rivet connections with punch rivets.