Prepare New Part
NOTE:
TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
NOTE:
RISK OF DAMAGE
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
- Only shift trunk lid slowly hand force.
- Mark separating cuts on new part in accordance with the separating cuts on vehicle + 15 mm extra material and disconnect.
- Adjust tail cowling in combination with trunk lid and rear lamps and secure.
- In area (1), set 22 bores of 4.2 mm diameter for blind rivet.
- Remove new part and deburr holes.