Install Outer Wheel Arch Section With Reinforcement

NOTE: TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment

Clean bonding surfaces (1) using solvent cleaner R1.
Apply adhesive K1 to bonding surfaces (1) .
Install new part and rivet the part in the areas (1) using blind rivet N11.
Weld the new part in areas (2) .
While doing so, avoid excessive application of heat to bonded rivet areas (1) and (3) .

Courtesy of BMW OF NORTH AMERICA, INC.
Weld new part in the areas (1) .
Avoid excessive heat input to adhesive areas (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Weld new part in the areas (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Install new part (2) and weld in the area (1) . Avoid excessive application of heat to adhesive area (3) .

Courtesy of BMW OF NORTH AMERICA, INC.
Install new part and weld in the areas (1) .
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of a cavity sealing (not expanding)
Apply sealant to cavity sealing (2) and install cavity sealing.

Courtesy of BMW OF NORTH AMERICA, INC.
Clean bonding surface (2) using solvent cleaner R1.
Apply K1 adhesive to bonding surface.
Install new part (3) and rivet with blind rivet N11.

Do not position blind rivets in area (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work