Install reinforcement strut
- Feed in reinforcement strut (4) .
- Tighten down screws (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Front reinforcement strut | ||
| screw Replace screws. |
Tightening torque | 19 Nm |
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Fold the trim panel (1) and attach it at the lever (2) by shifting it forward into the guide.
Follow-up work
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .