11 65 CHARGER WITH CONTROL (530e xDrive PHEV 2018-2020)
WARNING: This page does not describe the selected car, but rather 40 other vehicles, including the 2023 BMW 540i xDrive, 2023 BMW 540i, 2023 BMW 530i xDrive, 2023 BMW 530i, and 2023 BMW 530e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
11 65 TIGHTENING TORQUE OVERVIEW
| Electrical controller drive to exhaust turbocharger | ||
| M4 Disassemble all installation aids! |
Tightening torque | 3 ± 0.5 Nm |
| Electrical controller drive to exhaust turbocharger | ||
| Replace screws. Tighten screws crosswise. |
Tightening torque | 3 ± 0.5 Nm |
| Exhaust turbocharger support to crankcase | ||
| M8 x 20 Replace screws. |
Tightening torque | 19 Nm |
| Exhaust turbocharger to support | ||
| M8 x 25 Replace screw. |
Tightening torque | 19 Nm |
| Heat shield to cylinder head | ||
| M8 x 12 | Tightening torque | 19 Nm |
| Lock nut to control rod | ||
| Use the second open-end wrench for counter support! Use the special tool (gauge) to align the control rod! |
Tightening torque | 7.5 ± 1.2 Nm |
| Trim strip at the cylinder head | ||
| M7 x 27 Replace screws. Tighten from the inside to the outside. |
1. Assembly torque | 10 Nm |
| 2. Assembly torque | 16 Nm | |
| 3. Final torque | 16 Nm | |
| U bolt to special tool 2 919 (446) | ||
| The tightening torque must be observed! Risk of damage to the exhaust manifold! | Tightening torque | 1 Nm |
| Wastegate linkage to wastegate valve controller | ||
| M6 | Tightening torque | 5 Nm |