11 65 CHARGER WITH CONTROL (530e PHEV 2018-2022, 530e xDrive PHEV 2021-2022)
WARNING: This page does not describe the selected car, but rather 40 other vehicles, including the 2023 BMW 540i xDrive, 2023 BMW 540i, 2023 BMW 530i xDrive, 2023 BMW 530i, and 2023 BMW 530e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
11 65 TIGHTENING TORQUE OVERVIEW
| Electrical controller drive to exhaust turbocharger | ||
| Replace screws. Tighten screws crosswise. |
Tightening torque | 3 ± 0.5 Nm |
| Exhaust turbocharger heat shield on crankcase | ||
| M6X12 Replace screws. |
tightening torque | 10 Nm |
| Exhaust turbocharger support to crankcase | ||
| M8 x 20 Replace screws. |
tightening torque | 19 Nm |
| Exhaust turbocharger to cylinder head | ||
| M7 Replace screws. Replace nuts. |
1. Joining torque | 5 Nm |
| 2. tightening torque | 18 Nm | |
| 3. tightening torque | 18 Nm | |
| Exhaust turbocharger to support | ||
| M8 x 25 Replace screw. |
tightening torque | 19 Nm |
| Heat shield of exhaust turbocharger to cylinder head top | ||
| M8X12 Replace screws. |
tightening torque | 19 Nm |