11 12 CYLINDER HEAD WITH LID (530e xDrive PHEV 2018-2020)
WARNING: This page does not describe the selected car, but rather 40 other vehicles, including the 2023 BMW 540i xDrive, 2023 BMW 540i, 2023 BMW 530i xDrive, 2023 BMW 530i, and 2023 BMW 530e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
11 12 TIGHTENING TORQUE OVERVIEW
| Cylinder head cover to cylinder head | ||
| M6 x 27 | Tightening torque | 8 Nm |
| Tightening torque | 11 Nm | |
| Cylinder head on device | ||
| M10X90x1.5 | tightening torque | 30 Nm |
| Cylinder head on the special tool (press-out plate) | ||
| tightening torque | 35 Nm | |
| Cylinder head to crankcase/timing case cover | ||
| M8 x 40 Replace screws. |
tightening torque | 19 Nm |
| Cylinder head to crankcase (cylinder head bolt) | ||
| M11 x 188 13.9, screw head height 13 mm. Replace screws. |
Joining torque | 30 Nm |
| Joining torque | 50 Nm | |
| Angle of rotation | 90° | |
| Angle of rotation | 90° | |
| Angle of rotation | 90° | |
| Angle of rotation | 90° | |
| M11 x 188 11.9, screw head height 11 mm. Replace screws. |
Joining torque | 30 Nm |
| Angle of rotation | 90° | |
| Angle of rotation | 90° | |
| Angle of rotation | 90° | |
| Cylinder head to special tool 2 361 215 | ||
| tightening torque | 35 Nm | |
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Flange to assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |
| Front lifting eye on the cylinder head | ||
| M8 x 22 | tightening torque | 19 Nm |
| Heat shield to cylinder head | ||
| M8 x 12 Replace screws. |
tightening torque | 19 Nm |
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
| Special tool 2 456 190 to cylinder head | ||
| M6X20 | Tightening torque | 8 Nm |
| Venting connector/special tool to cylinder head | ||
| M10 Replace the venting connector! |
Tightening torque | 18 Nm |
| Venting connector/special tool to cylinder head | ||
| M10 | tightening torque | 18 Nm |