11 12 CYLINDER HEAD WITH LID (530e PHEV 2018-2022, 530e xDrive PHEV 2021-2022)
WARNING: This page does not describe the selected car, but rather 40 other vehicles, including the 2023 BMW 540i xDrive, 2023 BMW 540i, 2023 BMW 530i xDrive, 2023 BMW 530i, and 2023 BMW 530e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
11 12 TIGHTENING TORQUE OVERVIEW
| Bearing journal to cylinder head | ||
| Bearing journal Replace the bearing journal! |
Tightening torque | 22 Nm |
| Cover to rear cylinder head | ||
| M6 | Tightening torque | 8 Nm |
| Cylinder head bolt to timing case cover | ||
| M8x40 Replace screws. |
Tightening torque | 19 Nm |
| Cylinder head cover to cylinder head | ||
| M6X30 | Joining torque | 8 Nm |
| tightening torque | 11 Nm | |
| Cylinder head on device | ||
| M10X90x1.5 | tightening torque | 30 Nm |
| Cylinder head to crankcase | ||
| M11 Observe tightening sequence! Fit new cylinder head bolts. |
1. Joining torque | 30 Nm |
| 2. Angle of rotation | 90° | |
| 3. Angle of rotation | 180° | |
| Cylinder head to special tool 2 361 215 | ||
| Tightening torque | 35 Nm | |
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Flange to assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |
| Screw plug on cylinder head | ||
| M28X1.5 | Angle of rotation | 60° |
| Screw plugs on cylinder head | ||
| M28X1.5 Replace the screw plugs. Wet the screw plugs with Loctite. (Loctite 243) |
Tightening torque | 25 Nm |
| Sliding rail to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
| Special tool 2 456 190 to cylinder head | ||
| M6X20 | Tightening torque | 8 Nm |
| Support to cylinder head | ||
| M6X16 | tightening torque | 8 Nm |
| Venting connector/special tool to cylinder head | ||
| M10 | Tightening torque | 18 Nm |