11 11 ENGINE BLOCK (M550i xDrive 2018-2019)
WARNING: This page does not describe the selected car, but rather 40 other vehicles, including the 2023 BMW 540i xDrive, 2023 BMW 540i, 2023 BMW 530i xDrive, 2023 BMW 530i, and 2023 BMW 530e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
11 11 TIGHTENING TORQUE OVERVIEW
| (ASA collar screw) M11 | ||
| M11x99 Replace screws Screw in hand-tight |
Joining torque | 20 Nm |
| Angle of rotation | 115° | |
| Angled screw connection to crankcase | ||
| M8x37 Flanged head screw 10.9 Flat-head screw 10.9 |
Joining torque | 10 Nm |
| Angle of rotation | 45° | |
| Bearing cap to crankcase (ASA (ASA) collar screw) | ||
| M11x99 Replace screws Screw in hand-tight |
Joining torque | 20 Nm |
| Angle of rotation | 115° | |
| Bearing cap to crankcase (ASA collar screw 10.9) | ||
| M8X70 Replace screw. |
Joining torque | 10 Nm |
| Angle of rotation | 55° | |
| Bearing screws for M10 cylinders 1-4 | ||
| M10 Clean the threads with a thread cutter. |
tightening torque | 46 Nm |
| Oil nozzle to crankcase | ||
| M12x1 | Tightening torque | 10 Nm |
| Screw plug, main oil duct, rear, in V-space, right | ||
| M18x1.5 Replace gasket |
Tightening torque | 55 Nm |
| Screw plug, oil/water | ||
| M22x1.5 Replace gasket |
Tightening torque | 70 Nm |
| Special tool 11 8 930 to special tool 00 2 300 | ||
| M14x35 | Tightening torque | 160 Nm |
| Special tool to crankcase | ||
| M8x35 | Tightening torque | 20 Nm |
| Special tool to crankcase, rear | ||
| M10x35 | Tightening torque | 40 Nm |
| Threaded support sleeves | ||
| Tightening torque | 6 Nm | |