Removing and installing or replacing light strip on left or right rear door trim panel (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove LED for rear door trim panel lighting
IMPORTANT:
Risk of damage!
Exercise caution when handling lighting strip.
Do not strike the fiber-optic conductor against other objects.
Exercise caution when handling lighting strip.
Do not strike the fiber-optic conductor against other objects.
Grind off welding spots (1).
NOTE:
Only grind to base surface of door trim panel (2) so that contact surface is not damaged.
Feed lighting strip out of door trim panel (2).
Remove plastic remnants from contact surface of door trim panel (2).
Installation note:
Plane grind ribs (1) on tabs (2) on both sides.
Shorten front weld pin (3) by dimension (not for F34).
(X) = 3 mm
Installation note:
Carefully feed lighting strip into door trim panel.
Attach front/rear weld pins with lock washer (1) (not for F34).
Attach weld lugs (2) with clamps (3).
Clamps (3) must not rest on plastic reinforcement (4).
Check light strip is fitted correctly, if necessary press down firmer on lock washers (1) and clamps (3).