Replace button for tailgate activation (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

Attention !

Disassembly of the button is not possible without destroying it.

To avoid water ingress, the button must be replaced every time after disassembly.

Place special tool 00 9 327 at areas (A) between tailgate and button (1).

Destroy retaining tabs (2) in areas (A) by striking special tool 00 9 327.

Pull out button (1) from latch mechanisms (2) in area (B).

Disconnect associated plug connections and remove button (1).

Installation note:

Check tailgate for damage, touch up if required.

Perform function check with tailgate open.

Courtesy of BMW OF NORTH AMERICA, INC.

Version with reversing camera:

Unclip rear view camera (1) left and right and feed out of button holders (2).

Installation note:

Gasket (3) of rear view camera (1) must not be missing or damaged.

Courtesy of BMW OF NORTH AMERICA, INC.