Removing and installing/replacing outer door handle on left or right rear door (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove outer door handle COVER .

If necessary, lay outer door handle light (1) slightly to one side.

Pull out outer door handle (2) and feed out in direction of arrow.

Version with Comfort Access/CA:

Carefully feed out outer door handle (2) and disconnect associated plug connection.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Locator (1) must not be damaged.

Version with Comfort Access/CA:

Seal (2) must not be damaged.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Seals (1 and 2) must not be damaged.

In necessary, use string to pull lock actuation (3) outwards and hold in position.

Install outer door handle and insert correctly into lock actuator (3).

Remove string.

Mount outer door handle COVER and carry out function check with open door.

Courtesy of BMW OF NORTH AMERICA, INC.

After replacing version with Comfort Access/CA:

Clear fault memory and perform functional check using an appropriate scan tool/diagnostic system.