Removing and installing or replacing front grab handle (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Fold grab handle (1) downwards.
Disengage and remove locking wedge (2) with offset screwdriver (3), as illustrated.
Repeat procedure on rear locking wedge (1).
NOTE:
The version of the grab handle must be determined for the following procedure.
| Version | A | B |
|---|---|---|
| Stem length of locking wedge (1) | 22 mm | 15 mm |
| Retaining chamber (3) | No release tabs, fitted loose | Welded on grab handle, with release tabs (2) |
Only version A
Jerk back grab handle (1) until grab handle (1) detaches.
Only version B
Lightly pull grab handle (2) towards the inside by hand and hold under tension while releasing lower and upper tab (1) with screwdriver (3).
Remove grab handle (2) and place to side.
Installation note:
Only after grab handle (1) is snapped in correctly can locking wedges (2) we fully locked in position in grab handle (1).
Replacement
NOTE:
Only version B available as from September 2010.