Removing and installing/replacing front side panel trim on left or right (330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 327
The trim is secured with double-sided adhesive tape and can not be reused after disassembly.
Observe NOTES for securing components with adhesive tape.
Tape off side panel above trim (1) with yellow plastic adhesive tape.
Release trim (1) from latch mechanisms (2) with special tool 00 9 327.
Release double-sided adhesive tape in area (A) and remove trim (1).
Installation note:
Replace faulty clips (3).
Clean bonding surface.
Installation note:
Pull off liner (1).
Place trim (2) on side panel, clip in at top and press down evenly on adhesive tape.