Removing and installing/replacing support for rear bumper panel (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove BUMPER PANEL
Depending on version:
- Unscrew screws (1).
- Unlock and disconnect plug connection on Smart Opener control unit and bumper aerial
Loosen the latch mechanisms (2) at reinforcement (3).
Remove reinforcement (3).
Installation note:
Catches (2) must not be damaged or missing.
If necessary, feed out cable.
Unscrew nuts (1).
Tightening torque 51 12 1AZ .
Remove support (2).