51 11... Replace the holder for the PDC/PMA/side view camera (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- If necessary, remove the SIDE VIEW CAMERA , A FRONT CENTER LEFT (INSIDE) ULTRASONIC TRANSDUCER (PARK DISTANCE CONTROL) , A FRONT CENTER RIGHT (INSIDE) ULTRASONIC TRANSDUCER (PARK DISTANCE CONTROL) ,A FRONT LEFT (OUTSIDE) ULTRASONIC TRANSDUCER (PARK DISTANCE CONTROL) , A FRONT RIGHT (OUTSIDE) ULTRASONIC TRANSDUCER (PARK DISTANCE CONTROL) and ULTRASONIC SENSORS FOR PARKING MANEUVERING ASSISTANT .
Observe NOTES for bonding with adhesive tape.
The description of the work uses the example of a PDC holder.
If necessary, completely remove the faulty holder and adhesive residue.
Lightly sand the adhesive area (1) with sandpaper.
Clean the adhesive area (1).
Insert the ultrasonic sensor (1) in the holder (2).
Attention !
Mount holder (2) according to its installation position. Note the label on the holder (2) .
Align the visible notch (3) with the mark (4) and bond the holder (2) with the integrated ultrasonic sensor (1).
Fasten the holder (3) on the bumper panel in the area (5) on all sides with the ADHESIVE KIT K6 .