Install the rear top cross connection

• Guide in cross connection (3) and position it correctly.
• Replace screws (2).

  Parts:  Screws

• Tighten the screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear top cross connection to wheel arch carrier support
  M10x20 screw Replace screw.	Joining torque  Angle of rotation	56 Nm 90°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Reinforcement strut to rear cross connection
  Hexagon screw M 10x35	Tightening torque	56 Nm

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear cross connection at the top of the hood latch support
  Flat-head screw M6x20	tightening torque	11.8 Nm

• Mount the expanding rivets (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING THE FRONT-END STRUT .