Installing the luggage compartment wheel arch trim panel on the right

• Insert the luggage compartment wheel arch trim panel (3) and connect it with the corresponding connector.
• Secure expanding rivet (2).
• Insert the cover (1).
• Make sure the luggage compartment wheel arch trim panel (3) is correctly fitted at the edge protection of the trunk lid.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the lashing point (2).
• Tighten the associated bolt.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Lashing point to body
  tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the trim (1).

Follow-up work 

• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to REMOVING REAR SEAT BACKREST .
• Refer to INSTALLING THE REAR SEAT BENCH .
• Refer to INSTALLING RIGHT BACKREST SIDE SECTION .