Checking/topping up the oil level in the automatic transmission
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
Precondition
Vehicle in horizontal position.
The vehicle is secured against rolling away.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
To set the correct oil level, it is mandatory that the service function "Transmission control unit: Oil-level adjustment" is carried out with the diagnostic system.
To set the correct oil level, it is mandatory that the service function "Transmission control unit: Oil-level adjustment" is carried out with the diagnostic system.
NOTE:
TECHNICAL INFORMATION
Carry out an oil-level adjustment:
An oil-level adjustment is required when there are certain fault memory entries in the automatic transmission and after a repair has been carried out (e.g. replacement of the mechatronics, replacement of the converter, replacement of the transmission, automatic transmission fluid service).
Carry out an oil-level adjustment:
An oil-level adjustment is required when there are certain fault memory entries in the automatic transmission and after a repair has been carried out (e.g. replacement of the mechatronics, replacement of the converter, replacement of the transmission, automatic transmission fluid service).
NOTE:
TECHNICAL INFORMATION
The automatic transmission fluid specified by BMW must be used for the automatic transmission.
For additional information See: "Fluid Capacities" tab for the selected vehicle
The automatic transmission fluid specified by BMW must be used for the automatic transmission.
For additional information See: "Fluid Capacities" tab for the selected vehicle
- Connect diagnostic system.
- Observe the predefined transmission oil temperatures for the oil-level adjustment with the diagnostic system:
- Initial condition: Transmission oil temperature 30°C to 40°C.
- End condition: Transmission oil temperature 40°C to 50°C.
- Call up service function (drive).
- Carry out oil-level adjustment in accordance with instructions.
- Loosen the oil filler plug (1) using the special tool 2 405 614 .
- Top up automatic transmission fluid according to the instructions in the diagnostic system.
TECHNICAL DATA SPECIFICATION
| GA8HP76Z transmission capacity | ||
| min. 9.35 |
NOTE:
TECHNICAL INFORMATION
The setpoint torque deviates from the adjustable torque when using special tool 2 405 614 .
The setpoint torque deviates from the adjustable torque when using special tool 2 405 614 .
- Convert setpoint torque into adjustable torque:
(setpoint torque x L1): L2 =adjustable torque
L1 = length from the center of the grip to the reversible ratchet head
L2 = length from the center of the grip up to the insertion of the special tool in the screw
- Replace the oil filler plug (1) and the sealing ring.
Parts: Oil filler plug, sealing ring
- Make sure that the special tool 2 405 614 and the torque wrench (2) align while tightening the oil filler plug (1).
- Tighten the oil filler plug (1) with the special tool 2 405 614 and the torque wrench (2) .
TIGHTENING TORQUES SPECIFICATION
| Oil filler plug | ||
| M18x1.5 | Tightening torque | 35 Nm |