Tighten the front-end strut on the right
NOTE:
RISK OF DAMAGE
Use of an incorrect tool (impact screwdriver) to release and tighten the screws.
Damaged thread.
Use of an incorrect tool (impact screwdriver) to release and tighten the screws.
Damaged thread.
- Only use a standard tool (e.g. reversible ratchet) to release/tighten the screws.
- Clean the thread at shock tower.
- Replace the screw (1)
.
Parts: Screw
Tighten the bolt (1) of the strut brace (3) .
TIGHTENING TORQUES SPECIFICATIONFront-end strut, front screw
Joining torque 28 Nm Angle of rotation 90° - Replace the screw (2)
.
Parts: Screw
Tighten the bolt (2) of the strut brace (3) .
TIGHTENING TORQUES SPECIFICATIONFront-end strut, rear screw
Joining torque 56 Nm Angle of rotation 90° - Repair the damaged thread on the shock tower with a Helicoil insert.
CONSUMABLE SPECIFICATION
| Helicoil thread insert | |
| M10x30 mm | 07129909659 |