Installing the rear seat and the rear seat backrest (not for the SA465 pass-through system)

Remove rear seat backrest 

• Insert the rear seat backrest (2) and place the seat belt around the rear seat backrest (2).
• Hook the rear seat backrest (2) into the guides (3) from above.
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear seat backrest on body
  Screw Replace screw.	Tightening torque	42 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  Installing the rear seat bench 

• Place the rear seat and while doing so feed in the lower straps (3). 
• Connect the connector in the areas (2) and lock it.
• Clip the rear seat in the areas (1) into the detents downwards.

  Courtesy of BMW OF NORTH AMERICA, INC.