Fastening anti-roll bar on front axle support
- Correctly position the anti-roll bar (3) .
- Make sure that the retainers for the anti-roll bar and the upper sections of the holder are positioned correctly.
- Replace screws (1)
and (2)
.
Parts: Screws
NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position. - Tighten down screws (1)
and (2)
.
The screws have different lengths.
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |
TIGHTENING TORQUES SPECIFICATION
| Holder, stabilizer mounting to front axle support | ||
| M12 Replace screw. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |