US version only: Installing holder on left and right below the radiator
NOTE:
Perform the steps on the right and left side.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Loosen screw (2)
from the deformation element (1)
.
- Release and remove tensioning strap 0 496 080 (33 5 206) .
- Correctly position external radiator (1)
at the top holder (2)
.
- Correctly position bottom holder (2) on the external radiator.
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Holder for the external radiator on front axle support | ||
| screw | Tightening torque | 19 Nm |
Installing the front section of the front wheel arch cover
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Guide in the front section (1) of the front wheel arch cover.
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Wheel arch cover | ||
| screw | Tightening torque | 3 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |