Installing the anti-roll bar
NOTE:
RISK OF DAMAGE
Improper screw length can cause component damage.
The use of screws of improper length can lead to component damage.
Improper screw length can cause component damage.
The use of screws of improper length can lead to component damage.
- Note the correct screw length.
- Install screws that correspond to the original length.
- Position the anti-roll bar (3)
.
Make sure that the retainers for the anti-roll bar (3) and the upper sections of the holder are positioned correctly.
- Replace screws (1)
and (2)
.
Parts: Screws
- Tighten down screws (1) and (2) .
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |