Attaching the brake caliper on the left and right

NOTE: Perform the steps on the right and left side.

Securing the brake caliper

Release the special tool 2 413 317 from the brake caliper (1) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the brake caliper and slide onto the stud bolts.
Replace the nuts (1) .
Parts: Nuts

Tighten nuts (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Brake caliper on stud bolt of the front swivel bearing
M12 Replace nuts.	Tightening torque	95 Nm

Secure the brake hose on the holders (1) .
NOTE: Only perform the operation on the left side.
Attach the cable for the brake pad wear sensor to the holders (2) .

Courtesy of BMW OF NORTH AMERICA, INC.