Installing the left-hand charge air cooler

Replace hose (1).
Parts: Hose
Position hose (1) with hose clamps (2) as shown.
Replace hose (5).
Parts: Hose
Position the hose (5) and the hose clamp (3) (diameter 60-80 mm) at the top.
Ensure that the hose clamp at the top (3) in the area of threaded connection is aligned with the screw on boost pressure sensor.

Courtesy of BMW OF NORTH AMERICA, INC.
Position hose clamp (4) on hose (5) (diameter of 77-84 mm) at the bottom.
Ensure that the hose clamp at the bottom (4) in the area of the threaded connection is aligned with the rubber mount on the charge air cooler.
Guide in and position charge air cooler (2) at the bottom.
Tighten hose clamp (1).

TIGHTENING TORQUES SPECIFICATION

hose
hose	Tightening torque	3.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Connecting plate of charge air cooler
screw	Tightening torque	6.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect hose (2).
The retaining clip (1) must snap-in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Engage the holder (2) on the charge air cooler.
Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Charge air cooler top
M6x30 screw	Tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Charge air cooler bottom
M6x18 screw	Tightening torque	10 Nm

TIGHTENING TORQUES SPECIFICATION

hose
hose	Tightening torque	3.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

hose
hose	Tightening torque	3.5 Nm

Slide the hose (2) onto the studs of the charge air cooler.
Replace the hose clamps (3) and the hose.
Parts: Hose clamps and hose
Fasten the hose clamps (3).
Thread in the hose (1) in the holder on the charge air cooler (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Slide the hose (2) onto the studs of the charge air cooler.
Replace the hose clamps and the hose.
Parts: Hose clamps and hose
Fasten the hose clamps (3).

Feed the hose (1) into the holder on the charge air cooler (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the coolant lines (2).
The retaining clips (1) must snap-in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the cable in the cable bracket (2).
Lock the cable bracket (2).
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.