11 22 513 Replacing roller bearing for dual-mass flywheel (M5 2018-2022)
Special tools required:
- 21 2 051
- 21 2 052
NOTE:
Flywheel removed!
Using hydraulic press (1) and special tool 21 2 051 , press roller bearing out of dual-mass flywheel downwards on engine side.
IMPORTANT:
Risk of damage:
Roller bearing must not be driven out.
Roller bearing must not be driven out.
Push roller bearing (2) onto special tool 21 2 052 .
Using hydraulic press (1), press roller bearing into dual-mass flywheel to stop on clutch side.
IMPORTANT:
Risk of damage:
Observe press-in instruction:
Min. 2000 N 1 mm before end of pressing in.
Max. 15.000 N during entire press-in procedure.
Observe press-in instruction:
- Roller bearing must not be driven in.
- Roller bearing mounting force/travel monitored:
Min. 2000 N 1 mm before end of pressing in.
Max. 15.000 N during entire press-in procedure.