Installing the catalytic converter near engine, bottom at bank 1
WARNING:
Hot exhaust system
.
Risk of burning!
Risk of burning!
- Any work must exclusively be carried out with an exhaust system that has cooled down.
- Replace gasket (1).
Parts: Seal
- Position the catalytic converter at the bottom of cylinder bank 1 (2).
- Replace nuts (1).
Parts: Nuts
- Tighten nuts (1).
TIGHTENING TORQUES SPECIFICATION
| Firewall catalytic converter to catalytic converter near engine | ||
| Nut M8 Replace nuts. | Tightening torque Tightening torque |
17 Nm 28 Nm |
Follow-up work
- Refer to CONNECTING THE EXHAUST SYSTEM .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .