Install rear spoiler
Determine the correct position of the rear spoiler
Positioning the rear spoiler
- Apply the adhesive tape (1) according to dimensions A
to C.
The center adhesive tape (1) corresponds to the center of the trunk lid.
Adhesive tapes (1) cannot be located on the bonding surfaces of the rear spoiler.
- Mark the dimensions B and C
on the adhesive tapes (1):
Dimension A =310 mm
Dimension B = 367 mm
Dimension C = 365 mm
- Check the rear spoiler.
Do not install rear spoilers with poor fitting accuracy.
A rear spoiler loosely placed on the trunk lid must not protrude, especially at the corners.
- Transfer the mid-centring (1) via adhesive tape to the outer side of the rear spoiler.
- Place the rear spoiler (3) on the trunk lid and align to the adhesive tape.
Check if the rear spoiler (3) is centrally seated on the trunk lid.
- Clean the bonding surface on the trunk lid with R2 solvent cleaner.
- Detach the liner (protective film for bonding surface) (2), align the rear spoiler (3) as shown in the overview graphic and bond to the trunk lid.
Press down with force on the rear spoiler (3) using the hands over the entire area, in particular at the edges.
NOTE: The adhesion of the adhesive tape builds up significantly via the contact pressure. Therefore, press thumbs or fingers over the entire area. - Remove the adhesive tape.