Installing cover for the sport steering wheel

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Position the cover (2).
Connect the connector (1) for the steering-wheel heating and lock it.
Secure the connector (1) for the steering wheel heating to the holder.

Courtesy of BMW OF NORTH AMERICA, INC.
Check latch mechanisms (A) for damage.
The latch mechanisms (A) must not be damaged or missing.
Carefully clip in cover (1) at catches (A).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten screws (1) on the back of the steering wheel.

TIGHTENING TORQUE SPECIFICATION

Decorative trim to steering wheel
Screw TS5x12	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work