Install rear anti-roll bar

• Apply lubricant to the outer sides of the rubber mounts (1) at the rear anti-roll bar (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Position rear anti-roll bar (3).
• Position the retainer (2).
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to FASTENING THE REAR LEFT AND RIGHT ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR .
• Refer to LIFTING REAR AXLE SUPPORT .
• Refer to MOUNTING THE REAR AXLE SUPPORT .
• Refer to FASTENING THE WIRING HARNESS TO THE M SPORT DIFFERENTIAL .
• Refer to ATTACHING THE BRAKE CALIPER ON THE LEFT AND RIGHT .
• Refer to INSTALLING LEFT AND RIGHT COIL SPRING .
• Refer to FASTENING THE REAR LEFT AND RIGHT SHOCK ABSORBER TO THE BODY .
• Refer to SECURING CABLE OF REAR LEFT AND RIGHT WHEEL SPEED SENSOR .
• Refer to FASTENING THE CABLE FOR THE RIDE HEIGHT SENSOR ON THE REAR AXLE SUPPORT .
• Refer to SECURING THE PROPELLER SHAFT ON THE REAR DIFFERENTIAL .
• Refer to INSTALLING THE REAR HEAT SHIELD .
• Refer to INSTALLING THE REINFORCEMENT STRUT ON THE LEFT AND RIGHT .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
• Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .