Install the vibration absorber on the rear axle support
- Replace the clip nut (1).
Parts: Clip nut
- Position the vibration absorber (2) correctly.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Vibration absorber on rear axle support | ||
| M12 Replace the screw and clip nut. |
tightening torque | 28 Nm |
- Check the position of the vibration absorber (1), correct if necessary.
The vibration absorber (1) must not be twisted.