Install torsion strut
- Position the torsion strut.
- Replace screws (1) and (2).
Parts: Screws
- Tighten screws (1) and (2).
TIGHTENING TORQUE SPECIFICATION
| Torsion strut to front subframe/side member | ||
|---|---|---|
| M10x30 Replace screws. Screw in all the screws by several rotations . |
Tightening torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING THE UNDERSHIELD ON THE SIDES .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to ATTACHING THE FRONT LEFT WHEEL .