Check the gap dimension of the hood
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
Check
- Check the gap dimensions between the hood and the adjoining components.
TECHNICAL DATA SPECIFICATION
| Gap dimension hood to side panel | ||
| 1 hood; 2 side panel | a | 3.3 +1-1 mm |
| b | 0.5 +1.6-1.6 mm | |
TECHNICAL DATA SPECIFICATION
| Gap dimension hood to headlight | ||
| 1 hood; 2 headlight | a | 5.3 +1.8-1.8 mm |
TECHNICAL DATA SPECIFICATION
| Gap dimension from hood to bumper cover | ||
| 1 hood; 2 bumper cover | a | 3.5 +1.2-1.2 mm |
| b | 1.0 +1.5-1.5 mm | |
Desired state
- Gap dimension does not correspond to the secondary service information BODY DIMENSIONS .
Result
Gap dimension does not correspond to the secondary service information BODY DIMENSIONS .
Measure
- Adjusting hood.