Removing the engine from assembly jig
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- Attach the workshop crane with the special tool 0 490 579 (11 0 070) and position the engine (1)
.
- Release nuts at the special tool 2 413 082 .
- Detach the holder (2) in the direction of the arrow.
- Release the engine (1)
with the special tool 2 455 010
out of the special tool 2 413 082
in the direction of the arrow.
- Release the standard screws (arrows).
- Guide out and remove the special tool 2 455 010
at the engine (1)
.
- Variant with rear wheel drive:
Install the engine support bracket (2) .
Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONEngine support bracket on the engine M10 Tightening torque 38 Nm - Variant with all-wheel drive:
Install the engine support bracket (2) .
Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONEngine support bracket on the engine M10 Tightening torque 38 Nm